I-STEM Logo
Principal Sciencefic Logo

Equipment Info

Multijet and Thermal Jet Extrusion based 3D Printer

Equipment Info

Equipment Code : 2354026

Make : Cell Link

Model : Bio X6

Institution : CSIR Advanced Materials and Processes Research Institute (AMPRI) Bhopal

Department : Energy and Environmental Solutions Division

Funding Agency Details : CSIR

Pooling of Equipment slot :   No

AMC End Date (Valid Till) :  

PRISM Service Category (About PRISM) : D

Pre-Experiment Support (including sample preparation, setup assistance and pre-experimental guidance) :

Post-Experiment Support (including result interpretation, data analysis and post-experimental reporting) :

Equipment Certification (if any) (No document available):

Equipment Calibration (if any) (No document available):

Remarks / Special Instructions (if any):

Description : 1.The 3D bioprinter shall consist of a minimum three printheads. 2.UV curing capability between the range of 365 nm to 405 nm or higher 3.Enclosed in a Class-II, Type-A Biosafety Cabinet with laminar flow. Workstation access from the front of BSC with enclosure safeties 4.Pneumatic Control Printhead with size 3/5/10 mL or larger 5.Pneumatic Control Printhead with temperature range 30 0C - 60 0C or higher 6.Temperature Control Printhead with Temperature Range 4 0C to 60 0C at least 7.High Temperature Printhead for Thermoplastics with Room Temperature to 250 0C or higher 8.Syringe pump printhead with temperature up to 600C or higher 9.Piston Pressure Driven Extrusion Printhead with heating capacity Up to 65 0C or better 10.System should have an inbuilt compressor to provide a pressure range up to 200 KPa and system can withstand a pressure range between 5 to 700 KPa 11.Build volume minimum of 12.5 cm (length) x 9 cm (width) x 9 cm (height) or higher 12.Minimum of 5 Tool stor

Usage Rate: (as indicated by the custodian/host institution)


Samples External Academic User Internal Academic User Industry User Start-ups National Research Lab User Grassroot innovator
3D prinitng

Accessories / Consumables / Spare parts / Testing modes

Sample Name Sample Type Sample UOM Sample Availability Unit Cost Sample Quantity Sample Description
No Data Available

The Indian Science, Technology, and Engineering facilities Map (I-STEM) is an interactive web portal designed to accelerate scientific progress in India. This initiative, conceived and supported by the Office of the Principal Scientific Adviser to the Government of India, creates a centralized platform for sharing publicly funded R&D equipment and facilities across various institutions throughout the country.

Resources

 

  • Visitor Hit Counter

 

Copyright © 2026 I-STEM. All rights reserved Hosted at the National Informatics Centre, Delhi, India Audited by: STQC Bengaluru as on 26 Sep 2024